loading
 
Recognition Barcode and OCR only works if run roborealm as Administrator
Lev from Russia  [10 posts]
3 years
Recognition Barcode and OCR only works if run roborealm as Administrator
Steven Gentner from United States  [1370 posts] 3 years
Lev,

Can I assume:

1. You run RR using right click "Run As Administrator"
2. Load an image
3. Add barcode module --> code is recognized.
4. Exit RR
5. Start RR normally
6. Load same image
7. Add barcode module -> no recognition.

Is that correct? Could you post that barcode image here in the forum?

Thanks,
STeven.
Lev from Russia  [10 posts] 3 years
Hello STeven

With barcode could not repeat, I think it's my fault.

This forum thread has been closed due to inactivity (more than 4 months) or number of replies (more than 50 messages). Please start a New Post and enter a new forum thread with the appropriate title.

 New Post   Forum Index