Problems interfacing a PIC18F2455 roger santana from Mexico [1 posts]
Hi im triyn to use a PIC18F2455 IN cdc mode (as a virtual COM port)
when i use serial module of roborealm, my device is never recognized, so my question is:
in case that my code in the pic is correct, is there any bug, patch, or dll to use for roborealm, to recognize that device?
or is it enough whit MPUSBAPI.DLL ?
THANKS ANY HELP IS WELCOME
MY PROBLEM IS THAT MY DEVICE ISN`T RECOGNIZED EVEN BY DEVICE MANAGER OF THE CONTROL PANEL
Unfortunately your issue is not related to RoboRealm. It looks like you will need to download the device driver for whatever you are using to connect the PIC to the PC. You should check with the vendor of the cable you are using to connect the PIC to the PC. Typically they will supply the needed drivers to correctly register the cable as a virtual COM port based on their hardware.
If your device is not recognized by the device manager there is no way for RoboRealm to recognize it either.
This forum thread has been closed due to inactivity (more than 4 months) or number of replies (more than 50 messages). Please start a New Post
and enter a new forum thread with the appropriate title.