Very Slow
San  [1 posts]
15 year
I want to make a broken line flowing robot. But with the camera my servo is running very slowly. What should I do or change to make the servo run fast?
I am using Basic Stamp 2 Module with serial communication.
Anonymous 15 year

Does the camera fps increase when you disable the serial module? If so then your serial communication is what is slowing down the processing.

1. Ensure that you are using the highest baud rate possible.
2. Ensure that you are using the smallest data packet being sent to the BS2.
3. Are you using a wireless connection to the BS2? Like bluetooth?


This forum thread has been closed due to inactivity (more than 4 months) or number of replies (more than 50 messages). Please start a New Post and enter a new forum thread with the appropriate title.

 New Post   Forum Index