RoboRealm Forum

No Title

Tue, 30 Nov 1999 00:11:00 EST

Sorry, the CL_Eye modules were running in the Tab 2 and Tab 3 and I was using the call module to use them in the Main Tab, that is why you don't see them in the screen shot.

I didn't have the cameras set to save as marker. That seems to have done the trick. Thank you very much for your help and quick responses.

Tony

No Title

Tue, 30 Nov 1999 00:11:00 EST

Tony,

I realized from your screenshot that you are not using the CL_Eye module ... which you will need to use to access each camera. You can then set it to save the image as a marker which will then appear in other modules. Note that you would then use 2 of these modules to get each image.

http://www.roborealm.com/help/Code_Labratories_Playstation_Eye.php

Their driver interface does not show both cameras to DirectX and you have better control using the direct module interface.

STeven.

No Title

Tue, 30 Nov 1999 00:11:00 EST

Steven,

Yes, the SDK is installed and I have used it quite extensively with OpenCV in Visual studio. Using the Code_Laboratory_Eye modules seem to work properly and I have good capture with both cameras. Is there some way I need to link the SDK or designate the path to it in RoboRealm?

No Title

Tue, 30 Nov 1999 00:11:00 EST

Tony,

Did you install the right drivers from CodeLab? The free one only supports a single camera, the full SDK supports more than one.

STeven.

Multiple Code Laboratory Eye cameras not recognized in other modules.

Tue, 30 Nov 1999 00:11:00 EST

I have two CL_eye modules running in the pipeline. I am using the Code_Laboratories_Eye modules successfully for the two cameras, each has a unique GUID. When I try to use other "multi-camera" modules, they do not recognize that there are two separate CL_eye instances running and I can only select one camera in the drop down camera selections boxes ie. 'source' or 'current'. Is there any way to make the two cameras visible to these modules?

Thanks