RoboRealm Forum

No Title

Tue, 30 Nov 1999 00:11:00 EST

Erik,

Those boards are mixed in with the servo and motor control. You can use any board that has a serial interface by using the serial module. Specifically we have used the BS2, Axon, Velleman, Serializer, Nubotics, Vex, SV200 and Arduino to read IR and/or other such sensors. Note that you typically have IO abilities with most MCU's out there. Perhaps one of the few exceptions in the Phidget line of products which will connect directly to a PC.

The serial module can be found at

http://www.roborealm.com/help/Serial.php

STeven.

No Title

Tue, 30 Nov 1999 00:11:00 EST

I'm sorry but I don't see any input devices other than cameras. I am looking for a way to utilise ultrasonic and IR sensors.

No Title

Tue, 30 Nov 1999 00:11:00 EST

Yes, a whole bunch. Check out the RoboRealm help/documentation page and scroll down to the Control section.

http://www.roborealm.com/help/index.php

Sensors

Tue, 30 Nov 1999 00:11:00 EST

Are there any I/O boards that are supported by Roborealm? I would really like to be able to input data from sensors into Roborealm.