RoboRealm Forum

No Title

Tue, 30 Nov 1999 00:11:00 EST

Hi,
the Options button->Video Tab->Video Source button is also disabled.but anyway the image is right now.but I can't change the stream format and fps.
I use "watch variabe" to get fps about 25,it's right with my capture card.it's stand
pal, frequency is 40ms.

No Title

Tue, 30 Nov 1999 00:11:00 EST

In this case the camera is not important but we need the format of the video stream that you are using. Can you try

Options button->Video Tab->Video Source button

instead.

STeven.

No Title

Tue, 30 Nov 1999 00:11:00 EST

hi,steven,
The image is right now,I still don't know where goes wrong,Euresys PICOLO Tymo is a camera cpature card. I connect the card
with a different camera, then connect the camera which is skewed again, the image is corrected.Besides,Options button->Video Tab->Video Format button
is disabled.
thank you for your response.

No Title

Tue, 30 Nov 1999 00:11:00 EST

Richard,

Do you know what format you are using from the camera? Is it Y800, RGB24, etc.? You can see the format by going into Options button->Video Tab->Video Format button (which will popup a dialog) and see what comes under the format dropdown. Perhaps the format is a little different than expected which causes the image to be skewed.

What are the dimensions of your image when correctly displayed?

STeven.

No Title

Tue, 30 Nov 1999 00:11:00 EST

Hi,steven
My camera Euresys PICOLO Tymo can get right image from AMCAP, which is in directxsdk. but get a distort image in RoboReal. I woner how could i handle it.